3d Printed iPhone6+ clamp

I’ve been dying to try out the new time lapse photography on my 6+, but I haven’t had a great way to attach the larger iPhone to a camera stand. I could order up one from Amazon or something, but this is something that just screams for 3d printing.

I whipped up a quick clamp design that would fit the large phone and subtracted a hex hole for the mounting nut. One printout, some hot glue, and a few rubber bands later I had a camera mount.

The first version is fine for my purposes but the tolerances on the slider should be tighter, the edges in the band groves should be rounded to prevent band wear, and the whole thing could be slimmed down a bit to use less materiel.